SXK Delro D650 Boro Box Mod VW 5~60W, 1 x 18650, Compatible with BB / Billet Boro RBA / Tank

SDI60 Chipset
Input voltage: 3.3~4.2V
Battery: 1 x 18650 high-rate battery (not included)
Power: 5~60W
Voltage output: 1.0~8.0V
Quiescent current: 50uA
Resistance: 0.1~3ohms
Display: 0.42 OLED
Compatible with Boro / BB / Billet RBA / Tank


OPERATION/ CONTROLS
1. Switch ON / OFF: Press the power key five times to switch on or off, and "SYSTEM OFF" will be displayed when it is shut down.
2. Screen flip: Press the POWER button three times, and the screen display will flip 180 degrees.
3. Power adjustment: Press the UP button And DOWN button to adjust the power, the maximum power is 60W;
4. Key lock: Press and hold the up and down keys for 3 seconds to lock and UNLOCK the keys, The lock state is POWER LOCKED, and the UNLOCK state is POWER UNLOCK. When the keys are LOCKED, POWER LOCKED is displayed when you press keys, prompting you to unlock to adjust the power. The button lock function is only effective for the button and does not affect the use of the ignition key.
5. Record smoking times: The device will automatically record the number of smoking and display it on the screen, while holding down the ignition key and the reduction key to clear the value.
6. Long press the POWER button to make the nebulizer start to work, release the POWER button will stop the nebulizer work, the maximum heating time is 10S, more than 10s the device will automatically stop output.

SAFETY PROTECTION/ ERROR MESSAGES
Check Atomizer: If the device does not detect an atomizer no power output will be allowed. Pressing the fire button will display the "CHECK ATOMIZER" warning.
Low Battery: When the battery voltage is below 3.3V, no power output will be allowed. Pressing the fire button will display the "low battery" warning.
Over Voltage: When the battery voltage is detected to be higher than 4.3V, it is regarded as an abnormal power supply. No output power will be allowed, pressing the fire button will display the "HIGH VOLTAGE"
warning.
Overheat Protection: If the on-board temperature reaches an unsafe limit, no power output will be allowed. Pressing the fire button will display the "TOO HOT" warning.
Short Circuit: If there is a problem with the installed coil or the coil circuit is shorted no output power will be allowed, pressing the fire button will display the SHORTED warning.
Low Resistance Protection: If the attached atomizer is under the minimum specified resistance limit, no output power will be allowed.
Pressing the fire button will display the "LOW RES" warning.
High Resistance Protection: If the attached atomizer is over the maximum specified resistance limit, no output power will be allowed.
Pressing the fire button will display the "HIGH RES" warning.